Sql1767N Start Hadr Cannot Complete Reason Code 1

Sql1767N Start Hadr Cannot Complete Reason Code 1. 大家好，我在做数据库的hadr 配置， 配好后，启动的时候老师报下面的错。网上也搜不到报错码1 的情况。 请问怎么查这个错误？ 我初学db2 ，请大家帮忙看看，谢谢！ db2. Sql1767n rc 1 means that the standby (not primary) database is not in the correct state when you try to start hadr, and in particular, it is not marked as being ready for a.

Computer Service Mac / PC Laptop repair recovery software Microsoft from vancouvertechcomputer.blogspot.com

Assuming nothing else goes on, it should be possible to issue. Sql1768n unable to start hadr, reason code = 7 occurs while initializing high availability disaster recovery (hadr). Db2 start hadr on db itnm as standbysql1767n start hadr cannot complete.

Source: venturebeat.com

在开启standby hadr时报错如下：sql1767n start hadr cannot complete. Sql1767n rc 1 means that the standby (not primary) database is not in the correct state when you try to start hadr, and in particular, it is not marked as being ready for a rollforward type.

Source: vancouvertechcomputer.blogspot.com

Sql1767n rc 1 means that the standby (not primary) database is not in the correct state when you try to start hadr, and in particular, it is not marked as being ready for a rollforward type. Db2 start hadr on db itnm as standbysql1767n start hadr cannot complete.

The Knowledge Center Says This About That Error:

So, it's a wrong setting of host name or, ip address in the hadr parameter. Reason code = 5 means invalid service name for the hadr_local_svc configuration parameter. when configuring hadr the hadr_local_svc and hadr_remote_svc. Sql1767n rc 1 means that the standby (not primary) database is not in the correct state when you try to start hadr, and in particular, it is not marked as being ready for a rollforward type.

大家好，我在做数据库的Hadr 配置， 配好后，启动的时候老师报下面的错。网上也搜不到报错码1 的情况。 请问怎么查这个错误？ 我初学Db2 ，请大家帮忙看看，谢谢！ Db2.

The explanation corresponding to the reason code is: Assuming nothing else goes on, it should be possible to issue. Bit more here about the initial concern you mentioned.

Starting From Db2 V95 Fp8 And Db2 V97 Fp5, Takeover Hadr Will Fail With Sql1770N, Reason Code = 10 For Databases Which Has Names With _ In It.

A) start hadr as primary by force db2 start hadr on database as primary by force. The database is not recoverable as circular. The explanation corresponding to the reason code is:

The Database Was Not In Roll Forward.

The explanation corresponding to the reason code is: Symptom this is a generic error message which occurs when the. Deactivate db followed by activate db on a db.

(Static Functions May Not Be Resolved Correctly, As They Are Resolved To.

Hadr database type set to none (was physical). 大家好，我在做数据库的hadr 配置， 配好后，启动的时候老师报下面的错。网上也搜不到报错码1 的情况。 请问怎么查这个错误？ 我初学db2 ，请大家帮忙看看，谢谢！ db2. 在开启standby hadr时报错如下：sql1767n start hadr cannot complete.